01/2013PA6-GF15

Product description

A glass fibre reinforced injection moulding grade for housings with enhanced impact resistance (eg automotive mirror

housings).

Physical form and storage

The product is supplied dry and ready to use in moisture-proof packaging in the form of cylindrical or flat pellets. Its bulk

density is about 0,7g/cm³. Standard packs are the special 25kg bag and the 1000kg bulk container (octagonal IBC=

intermediate bulk container made from corrugated board with a liner bag). Subject to agreement other forms of packaging

and shipment in tankers by road or rail are also possible. All containers are tightly sealed and should be opened only

immediately prior to processing. To ensure that the perfectly dry material delivered cannot absorb moisture from the air

the containers must be stored in dry rooms and always carefully sealed again after portions of material have been

withdrawn. The product can be kept indefinitely in the undamaged bags. Experience has shown that product supplied in

IBCs can be stored for about 3 months without any adverse effects on processing properties due to moisture absorption.

Containers stored in cold rooms should be allowed to equilibrate to normal temperature so that no condensation forms on

the pellets.

Product safety

In case processing is done under conditions as recommended (cf. processing data sheet) melts are thermally stable and

do not generate hazards by molecular degradation or the evolution of gases and vapors. Like all thermoplastic polymers

the product decomposes on exposure to excessive thermal load, e.g. when it is overheated or as a result of cleaning by

burning off. Further information is available from the safety data sheet.

Note

The data contained in this publication are based on our current knowledge and experience. In view of the many factors

that may affect processing and application of our product, these data do not relieve processors from carrying out their own

investigations and tests; neither do these data imply any guarantee of certain properties, nor the suitability of the product

for a specific purpose. Any descriptions, drawings, photographs, data, proportions, weights etc. given herein may change

without prior information and do not constitute the agreed contractual quality of the product. It is the responsibility of the

recipient of our products to ensure that any proprietary rights and existing laws and legislation are observed.

In order to check the availability of products please contact us or our sales agency.

Ultramid® B3EG3

Product Information

Footnotes

1)If product name or properties don't state otherwise.

2)Specimens according to CAMPUS.

3)The asterisk symbol '*' signifies inapplicable properties.

4)Test box with central gating, dimensions of base (107*47*1,5) mm, processing condition: TM = 280°C, TW = 80°C下载本文