EN 13034: 2005 – Type 6 Protective Clothing
液态化学品防护服
Protective clothing against liquid chemicals
∙产品需要满足EN340:2003
该标准是防护服的一般通用要求，比如材料要没有刺激性，不能对健康有任何副作用。同时标准里规定了尺寸与标签要求。
∙Products must comply with EN340: 2003
This standard sets out the general requirements for protective clothing i.e. materials shall not be known to cause skin irritation or have any adverse effect to health. This also details garment sizing, labelling etc.
材料的测试要求：
Test Requirements for Materials
EN14325：2004里对材料的要求有非常祥细的描述。
EN14325: 2004 details the test methods & performance classification of chemical protection clothing materials, seams, joins and assemblages.
EN14325：2004章节
| Clause in EN 14325: 2004 | 测试项目 Test requirement | 规格 Specification |
| 4.4 | EN530 Abrasion Method 2 | >10 cycle |
| 4.7 | EN ISO 9073-4 Trapezoidal tear resistance | >10N |
| 4.9 | EN ISO 13934-1 Tensile Strength | >30N |
| 4.10 | EN863 Puncture Resistance | >5N |
| 4.12 | ISO 6530 (/ EN368) Repellency to liquids | >95% |
| 4.13 | ISO 6530(/ EN368) Resistance to penetration by liquids | <5% |
| 4.14 | EN 13274-4 Resistance to ignition Method 3 | 5s后自动熄灭 Not continue to burn for more than 5s after removal from flame |
Test requirements for seams, joins & assemblages of Type 6 protective clothing
接缝的针孔要防止液体穿透或是使其影响最小。
Seams should be constructed to minimise of prevent penetration of liquid through stitch holes or other components of a seam.
接缝的强度要符合EN14325:2004的章节5.5要求的1级
Seam strength is determined and classified in accordance with EN14325:2004, Clause 5.5 and must obtain at least Class 1
EN14325：2004章节
| Clause in EN 14325: 2004 | 测试项目 Test requirement | 规格 Specification |
| 5.5 | EN ISO 13935-2 Method 2 | >30N |
Spray Test for Garment
EN13034：2005章节
| Clause in EN 13034: 2004 | 测试项目 Test requirement | 规格 Specification |
| 5.2 | ISO 17491-4 (/ EN468) Spray Test Method A | Pass |
